Customer: Energy (Biomass Power Generation) Asset: 7.5 MW Steam Turbine and gearbox assembly (GTA) Location: Monthyon, France Initial Condition & Challenge No clear fault detected under standard operating conditions At higher loads, the machine exhibited increasing instability The issue was difficult
Machine & Event Overview Two identical GE 5002 32MW Gas Turbines, IDC 15 and IDC 16, were operating under similar conditions. Operational concerns were raised for IDC 15, while IDC 16 continued to perform normally. Vib360 Detection & Diagnostic Insight
Machine & Event Overview At a 12MW Groupe Turbo-Alternateur steam turbine installation in Suez, the equipment was experiencing occasional unexplained trips during operation. The issue appeared sporadic, with no consistent pattern, making it difficult to diagnose using conventional monitoring approaches.
Customer: Industrial energy production facility, Toulouse Asset: 7 MW Siemens Turbine and gearbox assembly (GTA) Industry: Energy recovery / industrial turbine systems Installation & Monitoring Initiation Following a shaft replacement in October using a previously used component, the Siemens turbine
Customer: Energy Biomass Power Generation Asset: 7.5 MW MAN DIESEL and TURBO Steam Turbine and gearbox assembly (GTA) Location: Orleans, France The Situation Initial Observation: Fluctuations of up to 7 RPM were observed in the turbine’s rotational speed during operation.
Customer: Industrial energy production facility Asset: 7 MW Turbine and gearbox assembly (GTA) Industry: Energy recovery / industrial turbine systems Initial Condition: Excessive vibration levels (>7 mm/s) detected by traditional accelerometers and displacement sensors after maintenance shutdown. Problem Statement Two
Customer: Global leader in waste management Location: France Turbine Make & Model: Thermodyne Rated Power: 10,000 rpm, 9.4 MW Driven Equipment: High-speed gearbox with alternator Operating Duty Cycle: Continuous operation Problem Statement The customer reported repeated turbine trips during startup
Customer: Large industrial energy recovery facilityAsset: Turbine train (GTA 1) 12 MWIndustry: Waste-to-energy / process industryContext: Monthly vibration checks and continuous displacement monitoring had not identified any anomalies. Problem Statement During a major shutdown on an adjacent turbine (GTA 2),